BP Mods Labs MTL RTA Dovpo

BP Mods Labs MTL RTA

The Labs RTA by BP Mods is a 22mm diameter rebuildable atomizer made by BP Mods in collaboration with the Guancia Vaping team (designed by Alen Tufekcic) and designed to offer a broad spectrum MTL experience .

The device is in fact equipped with 4 different bells that modify the aromatic yield of the steam and which can be replaced with a special tool, included in the package, as well as 6 different air-pins under the coil with fixed airiness (double hole 0.8 – 0 ,8 – 1.0 – 1.1 – 1.2 – 1.5 mm). The air flow starts from the side slots and hits the heating element from below.

Each bell has a different internal shape and is designed for a specific category of e-liquid:

• Bell with 3 low and squared steps : clean and dry aromatic yield, suitable for tobaccos
• Bell with double high and rounded vault : rich and moist aromatic yield, ideal for creamy
• Bell with double high and squared step : aromatic yield of medium humidity, excellent for fruity and creamy
• Bell with double rounded vault and lateral cavities : decomposed aromatic yield, which highlights the individual ingredients, ideal for tobacco mixtures and spiced liquids

The atomizer is made of stainless steel and has a frosted polycarbonate tank with a capacity of 2.7ml , which feeds the resistance through a top-down liquid dripping system. The single coil deck is equipped with two recesses on which to place the jigger, so as to facilitate the regeneration operations, and cross screws: accessed by “uncorking” the atomizer.

It mounts an interchangeable 510 drip tip and, thanks to the 510 connector, can be installed on any box mod or tube that has the same attack.

Elegant, austere and super eclectic: a “cheek” atomizer with great character and personality that stands out from the crowd.

Available in DLC or Stainless Steel versions.

Instructions for use :

• Regenerate the deck with the coil you prefer, insert some cotton inside and lay the edges in the vats for the liquid
• Wet the cotton with the desired liquid
• Regenerate the deck with the coil you prefer, insert some cotton inside and lay the edges in the vats for the liquid
• Fill the tank from below
• Install the bell of your choice under the tank, turn it upside down and install it on the deck
• Vape!

Features :

• Diameter : 22mm
• Vape type : cheek
• Liquid capacity : 2.7ml
• Refilling of the liquid : from the bottom
• Air regulation : under-coil air pin

Package contents :

• Labs RTA
• 6 x Air pins (double hole 0.8 – 0.8 – 1.0 – 1.1 – 1.2 – 1.5mm)
• 4 x different bells
• 1 x Bell Removal Tool
• 1 x Bag with o-ring and spare screws
• 1 x Instructions for use